If moisture is driven deeper inside, corrosion and oxidation may result when minerals from liquids are deposited on the circuitry. Do not use a hair dryer (even on a "cold" mode) to dry out the phone, as this may force moisture further into the small components, deep inside the phone. Dry the excess moisture by hand.Remove any covers and external connectors to open up as many gaps, slots, and crevices in the phone as possible.Use a vacuum if possible. Shake it out without dropping it, then use a towel or paper towel to gently remove as much of the remaining water as possible. Obviously you need to remove as much of the water as soon as possible, so you can save it from getting into the phone. Just pat it dry and leave it aside until you need to connect your phone to your cellular network.Dry your phone. SIM cards survive water damage well, but some of the following steps are unnecessary i.e. To some people this could be more worth saving than the phone itself. Some or all of your valuable contacts (along with other data) could be stored on your SIM. This will ensure that un-necessary damage to your memory card is avoidedRemove your SIM card. Many circuits inside the phone will survive immersion in water provided they are not attached to a power source when wet.Remove the memory card. Cutting power to your phone is a crucial first step in saving it. Don't take time to think about it electricity and water do not mix. Water helps dissipate heat from shorts that can damage the phone, so most damage occurs when the inside of the phone is merely wet and there is a power source.Remove the battery. So grab your phone quickly! If you can't get to it in time, your best bet is to remove the battery while it is still under water. The plastic covers on cell phones are fairly tight, but water can enter the phone in a short period of time, perhaps only 20 seconds or less. Do not attempt to use even if itappears to be working and then follow the steps below:Get it out of the water as soon as possible. If yourphone is on switch it off immediately. If liquid comes into contactwith the electronic board inside a phone, any metal components ittouches will corrode and can cause short circuits on the board.What to do after your phone comes into contact with liquid?DO NOT TURN ON POWER! In doing so the board will be fried. Mobile phones, like laptops and other electrical devices, are notresistant to water or any other liquid.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |